Lubrication Accessories
Techno Drop produces a variety of spares parts for different types of lubrication systems & for the field of lubrication. The range of products include flow switch, float switch and pressure switch. These can be used in different applications and requirements and are available at economical price.
Model TDMHP - 7
MODEL TDMT - 002 (No. of outlets-2)
MODEL TDMT - 003 (No. of outlets-3)
MODEL TDMT - 004 (No. of outlets-4)
The Take OFF metering injectors are made of zinc (pressure die casting) material.
The Take OFF metering injectors works on a different principle unlike the normal metering injectors which discharges the oil when pump is ON. In this case when the pump is ON the TAKE OFF injectors are charged and the spring loaded piston ejects (Pin) out thereby indicating TAKE OFF injectors are charged. When the pump stops the oil is flushed out from the injectors to the lubricating points and the piston goes back. A non return valve in each injectors does not allow oil to go back.
Manifolds(For TDMI-1 & TDMI-2 Injectors)
.jpg)
TDM- 1 One Way ( for Single Injector)
TDM- 2 Two Way ( for two Injectors)
TDM- 3 Three Way ( for three Injectors)
TDM- 4 Four Way ( for four Injectors)
TDM- 5 Five Way ( for five Injectors)
TDM- 6 Six Way ( for six Injectors)
TDM- 7 Seven Way ( for seven Injectors)
TDM- 8 Eight Way ( for eight Injectors)
TDM- 9 Nine Way ( for nine Injectors)
TDM- 10 Ten Way ( for ten injectors)
Metering Cartidge
TDMI-1
with Dosage 0.01 cc, 0.03 cc, 0.05 cc, 0.10 cc, 0.16 cc Per Stroke
TDMI -2
With Dosage 0.25 cc, 0.40 cc Per Stroke.
TDMI -3
With Dosage 1.00 cc, 1.60 Per Stroke
Note : Above metering injectors are available in M.S. as well as brass with honed bore Nitrile rubber parts & accurate dosage.